View Full Version : CD624 PSU Problem, display dead, ttm motor running

01-12-2013, 04:07 AM
I have a CD624 which I found to be best in any class by miles some years ago when it appeared ( an 'integrator',
1 bit player). I asked for a circuit diagram via customer support which promised a response in 48 hours........over a week and counting...........
Would like to fix since choices of kit limited in NZ. Have found a diagram on the interweb and slowly going through measurements, display voltages seem okay, have to go through the other supply voltages (other than TTM I guess) .
Any thoughts welcome if anyone has come across this before.,
/cheers tim

Philips - Katerina
08-27-2015, 02:38 PM
Hello participants of the thread and forum members in general!

Hopefully your issue was dealt with and you are no longer facing it. Since the thread has been silent for some time now, I will proceed by closing it. If you still have the same question about the same issue or any similar issues arise feel free to start a new thread or contact one of us moderators to open this thread again.

Kind regards
Philips Katerina