View Full Version : Dcm 5090

Francisco Munoz
01-23-2013, 02:10 PM
I am asking this question for a second time as i have not received any leads. Bought a DCM 5090 in late November. From day one, the system wrks well, only after unplugging and plughing again. Everything works including the remote. If i turn the device off or put it in Eco then two things happen:

1. The system starts and automatically goes off after some minutes.
2. The system will not respond to the remote control.

I can always unplug and plug again, but i assume that a device that costs over 350 Euros should work in the ways it is supposed to work.

Is this a software issue? How could I undate the software?

Any other elads?

Thanks in advance.


Philips - Katerina
08-26-2015, 01:38 PM
Hello participants of the thread and forum members in general!

Hopefully your issue was dealt with and you are no longer facing it. Since the thread has been silent for some time now, I will proceed by closing it. If you still have the same question about the same issue or any similar issues arise feel free to start a new thread or contact one of us moderators to open this thread again.

Kind regards
Philips Katerina