PDA

View Full Version : MCM3000 Sound stops after 2 sec



petdra
05-08-2013, 06:30 PM
Hi all

I bought a MCM3000 audio system 1 year ago: works fine until today.

Whatever the input source is, the main speakers doesn't work anymore except when: I put the device in eco mode (red light on), start it, then the sound runs for 2 secs then stops.

The front output audio plug still works... I did a firmware update and I unplug 1 of the 2 speakers: it is the same.

Anybody has an idea ?

Thanks

Faust
05-09-2013, 09:12 AM
I suppose you already tried to reset the device completely (unplug it for a little while and plug it back)? if this does not work, i would actually contact your local service centre to have it checked and fixed.

petdra
05-09-2013, 10:41 AM
Hi Faust

Yes I did: unplug it completely and wait few minutes then the same

It gives me the feeling that the amplifier goes into security mode. before sending it back to the service center, I wil open it to check if I don't find any shorts.

Thanks

Philips - Katerina
08-24-2015, 08:50 AM
Hello participants of the thread and forum members in general!

Hopefully your issue was dealt with and you are no longer facing it. Since the thread has been silent for some time now, I will proceed by closing it. If you still have the same question about the same issue or any similar issues arise feel free to start a new thread or contact one of us moderators to open this thread again.

Kind regards
Philips Katerina