PDA

View Full Version : TV does not start after firmware update, 7 flashes then nothing



jvdwolde
11-13-2011, 01:13 PM
Hello All
I tried to update my 42PFL9603D/10 tv because the tv could not handle my set top box via HDMI, no image.
I have downloaded and installed the nieuw firmware ( i probably should have downloaded the software huh?)
Then i needed to start up the tv, so i switched it off via the remote control and also used the on/off switch....that was a mistake!! now it only flashes 7 times (the light under the screen) and then nothing!
Please help!!!

Thanks.

Jack

jvdwolde
11-13-2011, 02:50 PM
It works again! even the HDMI works on the set top box!
I left the AC plug out for a couple of hours and it startet up!
Thanks!