PDA

View Full Version : New firmware v1.27 available for HTS7201 / HTS7202 / HTS72121 /HTS9221 / HTS9241



Philips - QK
01-03-2012, 01:46 AM
Details:
For this release, there is no change in the main software, ie. the software version is still V1.27. Only change is the MCU software.

HTS7201 / HTS7202 / HTS7212 - V1.27 MCU 27
• Improved playback performance
• Solved wireless speaker volume adjustment issue
Note: All the above models uses the same bin filename - HTS_7201.bin

HTS9221 / HTS9241 - V1.27 MCU 27.12
• Solved no sound from speaker issue
• Improved playback performance

Kindly download the latest software from P4C at www.philips.com/support

DerShortyy
01-06-2012, 09:06 AM
Hi QK,

which Opera USER-AGENT is implemented in the HTS9221?
Best regards

kwinnie
01-10-2012, 04:06 AM
You can check the Opera User-Agent from the Open Internet from NetTV and go to http://whatsmyuseragent.com/.
Let us know if you experience any problems.

fam
02-05-2012, 08:53 AM
Thxs Philips QK
I've just implemented this firmware on the HTS 7200. I also send you an private message inwhich I stated that I could not upgrade the system. After a new donwload from the appointed site and the user's manual (which couldn't been seen with FIREFOX, I could see it only with COMODO DRAGON browser) I managed to upgrade the system. It works I think at least I've the most "normal"indications that I used to have 20 hrs ago.:rolleyes:.
So thanks to U all.

tobiasb
02-09-2012, 07:00 AM
Hey there,

I have a HTS9241/12 and the v.1.27 firmware installed. I have since this firmware a bug with the touch button on the device head. My HTS9241/12 is connected to the 42PDL7906K/02 via HDMI (ARC). So if I turn on the TV the HTS follows. And sometimes the touch buttons on the device head stay in standby mode, means the HTS is on but the touch buttons are in standby mode and the power on button is red.

Maybe you can give this information to your software developers to fix that little bug ;)

Bye
Tobias

pmzwagerman
02-27-2012, 06:36 PM
Hi there, thanks for the new firmware, but I encounter the following issue:

- Using HTS7202/12
- Using Cisco DVB decoder/recorder

1st I start my Cisco
2nd I start the HTS

Then I have no sound using Optical Fiber
I have to put the HTS in stand-by mode and start the HTS again, then I immediatly get sound.

DerShortyy
02-28-2012, 07:14 AM
Hey there,

I have a HTS9241/12 and the v.1.27 firmware installed. I have since this firmware a bug with the touch button on the device head. My HTS9241/12 is connected to the 42PDL7906K/02 via HDMI (ARC). So if I turn on the TV the HTS follows. And sometimes the touch buttons on the device head stay in standby mode, means the HTS is on but the touch buttons are in standby mode and the power on button is red.

Maybe you can give this information to your software developers to fix that little bug ;)

Bye
Tobias

I can confirm this behaviour on my HTS9221. When you get near to the HTS the touch bottons begin to light again.

It is also not possible to stream music to the HTS9221, which is very annoying if you donīt want to turn on the TV too.