teochs
04-02-2012, 12:59 PM
Hi everybody,
I've a BDP 9500 which recently has shown a problem with BD playback (HDMI connection).
Despite the HDMI Audio is set on "Auto" and the player display correcttly shows DTS AUDIO (for example) the amplifier always receive a PCM signal...
I tried to:
- change the player audio settings (e.g. from Auto to Bitstream)
- restore the player to factory settings
- update the player firmware, even if it was the 1.09 already
- use a different BD player: in this case everything works properly, so the problem is not depending on the amplifier
Have you got any suggestions???
Thank you,
ciao
Matteo
I've a BDP 9500 which recently has shown a problem with BD playback (HDMI connection).
Despite the HDMI Audio is set on "Auto" and the player display correcttly shows DTS AUDIO (for example) the amplifier always receive a PCM signal...
I tried to:
- change the player audio settings (e.g. from Auto to Bitstream)
- restore the player to factory settings
- update the player firmware, even if it was the 1.09 already
- use a different BD player: in this case everything works properly, so the problem is not depending on the amplifier
Have you got any suggestions???
Thank you,
ciao
Matteo