View Full Version : HTS3410D AM Antenna

Anna Dent
09-02-2012, 04:20 PM
I have had a Philips HTS3410D system since 2005 and like it very much. My AM Loop Antenna Part #996510003608 has the 1/4" square connector broken off, now just have the to wires at end. I tried to by anrenna at 4 online parts places and it was no longer in stock. I tried to buy a new replacement at both Radio Shack and Best Buy and the generic AM antennas wont fit this HTS unit with the odd little quarter inch square connector. Not wanting to give up, is there anything that I can put on the tip of the antenna wires that will work as an AM conductor? Any other ideas about a quick improv fix? Thank you.

Philips - Katerina
08-24-2015, 11:19 AM
Hello participants of the thread and forum members in general!

Hopefully your issue was dealt with and you are no longer facing it. Since the thread has been silent for some time now, I will proceed by closing it. If you still have the same question about the same issue or any similar issues arise feel free to start a new thread or contact one of us moderators to open this thread again.

Kind regards
Philips Katerina