PDA

View Full Version : Setup problem



kath
11-01-2012, 06:51 AM
Hi there,
since this forum is quite quiet, I am not sure if any of you can help me with the set up of my new M100.

During the setup, there is a page to ask you to hold your M100 in front of the QR code. But usually when come to this step, the pairing failed... (sometimes is ok, after a few trials)

Any of you experience this before?

kwinnie
11-01-2012, 07:31 AM
i hv this issue before as well and later got reminded by a friend that i hv to place the phone 15 cm from the QR code. not too close. after that, my pairing is fine. hope this help you as well.

kath
11-01-2012, 07:34 AM
Thanks for your quick reply Kwinnie. I will indeed try and let you know.

Philips - Katerina
08-21-2015, 12:38 PM
Hello participants of the thread and forum members in general!

Hopefully your issue was dealt with and you are no longer facing it. Since the thread has been silent for some time now, I will proceed by closing it. If you still have the same question about the same issue or any similar issues arise feel free to start a new thread or contact one of us moderators to open this thread again.

Kind regards
Philips Katerina