View Full Version : AD7000W forgets all sound settings after power off

11-29-2012, 10:14 AM
I own the AD7000W which i really like, except that all EQ or soundsettings done through DockStudio App are reset when the speaker is turned off. I also have the DS9800W and this one remebers all settings, even after a full reset oder firmware upgrade. Any chance to make the AD7000W remember which EQ it had active the last time?


11-30-2012, 10:13 AM
How can you see this exactly? If the case then it is the app having the issue and not the device

11-30-2012, 10:18 AM
the settings are always stored in the (flash?) memory of the speaker not in the app. if i uninstall the app i still have the speaker working with all the EQs as they were set. the app just controls the settings remotely.

the problem is that if you power off the AD7000W it will reset all EQ-settings to their default values. I usually tend to turn on "full sound", but when the speaker is put into standby, "full sound" is deactivated automatically.
my DS9800W doesn't do this, it remembers all settings even if i shut it down completely.

Philips - Katerina
08-21-2015, 09:00 AM
Hello participants of the thread and forum members in general!

Hopefully your issue was dealt with and you are no longer facing it. Since the thread has been silent for some time now, I will proceed by closing it. If you still have the same question about the same issue or any similar issues arise feel free to start a new thread or contact one of us moderators to open this thread again.

Kind regards
Philips Katerina