Philips Gogear Spark 4GB Freezing on startup
Hello, I've had this Philips GoGear Spark 4 GB for about 1 to 2 years now and it's been quite good, although charging has been glitchy once in a while.
Unfortunately, today it started being unresponsive to the startup button. I CAN make it start by putting it in the computer and "charging" it (I don't think there's any real connection, as the computer doesn't seem to know anything about the device being connected) and then unplugging it from the computer, making it auto-startup.
Thing is that, even then, it freezes as soon as it reaches the Philips logo, never continuing to the Gogear Logo or any useful function.
I've already tried the Reset button, that did nothing, and since the computer doesn't seem to know that the device it plugged in, the Device Manager does nothing.
Please, this is my only source of music for at least the next year.. I can't just buy a new one, because I'll be abroad for the next year and can't reach my music collection.
BUMP - I don't usually do that, but I am really heavily desperate by now..
Might be worth trying to charge your MP3 player for a minimum of 3 hours before trying the reset again (when connected to the PC). Sometimes you have to hold down the reset button longer than 10 seconds for it to reset.
Once you have reset connect the player to your PC but make sure you hold down the recovery key. This is usually the Volume + key on the player. Without doing this the device manager my not recognise your device.
Here's a full FAQ on repairing your player: http://www.p4c.philips.com/cgi-bin/d...archtext=reset
Hope this helps
well, I have tried for quite a while ( not entirely 3 hours), but I don't think it'll work, as it doesn't seem to make a proper connection to the computer - the computer doesn't say that it's found an extra drive/usb/input or anything.
the main problem with charging it for 3 hours is that I can't be anywhere near the computer for 3 hours, as the charger cable is very picky with placement (if I move the player/computer a millimeter, it will fail).
I already read the FAQ
Thanks for the reply! much obliged
If the cable is picky with placement and does not work when you move it slightly then it may be that the cable is damaged in some way. Do you have another USB cable to try? or have you tried an another USB port on your PC?
It's not my PC - it's the same thing on both my stationary and laptop, and other USBs work fine.
It may be the cable, but It's always done the job in the end, so I doubt that it's the root of the whole problem. I could try switching the cable and see if it's less picky, but to be perfectly honest, I doubt that charging it for a longer time will make a difference..
EDIT: I found a better cable, I'll try to charge it for about 4 hours and see what happens.. hopefully that'll work. if not, are there any options left for me?
(it says OK to disconnect already.. doesn't bode well, I don't think)
Last edited by Jaster; 09-16-2011 at 03:31 PM.
I just charged it for 4 hours or so and reset it and... nothing
it's still as unresponsive as ever.
Philips - Cassandra
Thanks for joining our sound support forum!
Usually the reset and repair through the device manager/songbird will resolve issues similar to yours.
As you are still having a problem with your MP3 player after trying all of the troubleshooting I have sent you a private message with further information for you.
Please check your inbox!
I have same problem too..
I bought my philips gogear spark 4 months ago, and now the spark freezing at startup.
Please someone help me ..
Philips - Cassandra
Try resetting your player by holding down the reset button for about 10 seconds. If your player still is freezing when it starts up I would suggest trying the following:
1. Connect your player to your PC
2. Open the songbird software and use the repair mode through songbird.
Before using the repair mode in Songbird it is important that the version of songbird is correct for your player. If you are not sure uninstall and download the correct version from the support page.
If the repair mode does not work to resolve this please provide me with the model number and the songbird version that you are using to help you further.
btw.. its taking a hell lotta time for it to get fixed - -
yep it can take up quite long if you do it the first time. seems your process goes quite well !
actually, so when we hv this freezing problem or whatever other problem... there are 3 steps to solves this...
1) Reset > just to press the reset button using a pen tip or a pin
2) if that doesnt work, then try upgrade the firmware or format. songbird > device pane > tools tab> upgrade firmware/ format player
3) if the above doesn't work also, then we try repair...
so repair is always the last steps... also to do repair, the data inside the device will be gone. but if just to upgrade firmware, the info will still be there.