DVB-T searching problem on FW 9.22

[Blaza]

Hi

I have 40PFL9715/02 TV with 9.22 firmware.
THere are problems when trying to search for new DVB-T channels. There is no such option as update digital channels list. So I can go and do a complete rescan (analog + digital) but this deletes my current list with names etc.

There is also the option in Configuration to Test signal: Digital. There I can put custom frequency to search for channels. I haven't been able to find so antything yet. But after each search I loose access to previously viewable channels with an error message "no channels avaiable". I have to shut down the TV and start it up again. Then the previously found channels are avialable again.

BTW. It would be great to have an option like with analog channels to update digital channels

PS. I'm translating the options name s from Polish so sorry if there are some mistakes.

[a_Tom]

what Provider do you use?

[Blaza]

I'm using Polish national DVB-T provider operated by Emitel. They have currently two MUX (DVB-T started this year and there should be 3 MUX avialable by the end of 2012). I'm using frequency 698MHz.
But the problem is not getting a channel to work but to do a search. After each (unsuccessful) search all the previuosly saved channels are not working. You have to restart the TV to get it work again.

[Philips - Thomas]

Hi Blaza,

Please get in Contact with your local Call Center:
http://www.support.philips.com/suppo...jsp?COOKIE=off

Regards
Thomas

[Blaza]

Okey.
Local Call Center was very helpful. The trick to scan only for digital channels is to select different country (Finland was suggested) and then one can disable analog channels scanning and update digital channels list. This was completed succesfully ))

According to support this was because Poland DVB-T was not certain when the TV was produced.

My suggestion would be to enable the same search functionality for Poland as it is now for Finland in a new software!