Problems 7606/7656 (Sound/Shutdowns....)

[iceraul]

Dear Support

I have some Problems with the 42" 7656

I have installed the newest Firmware.
I have testet a Hardware Reset but the Problems are still on

Problem
- TV shut down without my Action , this comes 1-2 Times on a Day
- sporadic outages tone , comes every 30-90 Minutes , the failure is 1-2 Seconds , after this the sound is OK

No good, many Peoples have the same Problems.

[iceraul]

any new Infos about the Technical Problems?

TV Shut down to Standby after 2 Hours , after a new Turn On its OK.

[jjs]

Install 0.14.84.0 many bugs solved

[iceraul]

newest Firmware already installed.

tv completed backset (@worksreset)

sleeptimer is "0"
automatic shutdown is disable

tv goes to standby after 2 hours running time, after that the tv runs on the day without that.

next day the same

[Toengel]

Hi,

i think it is a bug - this is also reported in other forums... I think you need to wait for an upcoming firmware release...

Toengel@Alex

[Goodkyng]

Just to let you know.

Same problem here with 42PFL7606H / FW 14.84
It turned into standby yesterday evening for the first time, while we were watching TV.

I hope this will be solved by next FW

[jjs]

As far as i know, they are working to solve this problem.
14.84 was mainly solving a ziggo (NL) problem. People had intermittendly no reception anymore.

[iceraul]

i have this problem also with the older firmwares.
my tv have this problem if i buy the tv.
after that i made 2-3 fw updates , but the problem is still on

old or new firmware, the 2hours shutdown to standby is always the same.

[bulkin2000]

I have the same problem.
Every day, exactly after 2 hours, TV goes to Standby mode. And after turning it on again, it works finely, till the end of day.
Next day - the same
Seems like some strange hidden timer...

model: 40PFL6606/12, firmware is 000.014.084.000
Sleeptimer is "0" , auto-shutdown disabled.
I did "hardware reset", and reset from menu - still the same.

[uli]

I have the same problem.
Every day after about 2 hours, TV goes to Standby mode. This is very annoying.

Is this bug confirmed by philips?

model: 32 PFL6636K/02
firmware: 000.014.084.000
Sleeptimer is "0" , auto-shutdown disabled.

[Toengel]

Hi,

yes - this bug is known and confirmed...

Toengel@Alex

[hansje]

there are also T-models, they use software 14.88
this software does not have the problem of 2 hours
if that is used for the H-model then your problem is solved

[sasa']

same problem after firmware up grade

ther is a conflict with pta01;
without pta01 there are less shutdown

another prolem for my 42pfl7606m 08,
There are areas of the panel that are brighter, and this is seen with the black panel

[jjs]

I have the same problem.
Every day after about 2 hours, TV goes to Standby mode. This is very annoying.

Is this bug confirmed by philips?

model: 32 PFL6636K/02
firmware: 000.014.084.000
Sleeptimer is "0" , auto-shutdown disabled.

this had to do with the auto-update at night.
After the auto-update the set would not go fully into standby but semi-standby
Turning the set on and then in standby solved it temporarely until you leave it in standby at night and it starts again (even if you had auto-update off it is not totally off) or using the on/off switch
so this has been solved indeed

[iceraul]

i think i have disable the auto update function.

and on the mainsite the fw is always last weeks 14.84

its time to solved the problem, very angree the tv shut down 1st time after 2hours