12-18-2011, 09:25 PM #1
- Join Date
- Dec 2011
- Thanked 0 Times in 0 Posts
- Rep Power
Better and faster User Interface
In general the menu of the Philips 9706 is very slow, it should be faster and more responsive. There was an improvement from the first firmware, but it is still slow.
There should be a separate key for the TV GUIDE, it should be possible to select a certain programm which just pressing a key and it shouldn't be necessary to do this in a additional sub menu.
It is completly unnecessary that the adjust Function only shows 3 buttons, if you want to access Ambilight or 3D you have to press left, then the Smart Menu zooms down slow, zooms up again, and shows the next 3 funtions. Why not use the same layout as in the home menu? Or at least use up and down keys to go to the next menus.
In general it would be very useful if you allow that the user to add or removes functions to each of the menus. Because the function Speaker in the Smart Menu is used I think only once after you installed the TV, but the 3D Menu with the 2D->3D Calculation is used much more often.
At the moment you have to do the following to change one of the settings
right (now you are over Configuration)
Press OK (now you are in Configuration)
and now are able to select one of the predefined picture settings to modify them.
Sometimes I would prefere to switch PNM or Noise Reduction on and off very fast, but I do not want to change the other picture parameters.
A easy solution for this could be, without any change on the hardware. Allow the user to assign Hotkeys to some functions.
For example the yellow and green key are normally not used if you are not in a menu. The function on the blue key with energy saving is I think not used that much.
You could allow the user to assign functions like TV Guide, Picturesettings, current TV Programm, usb recorded prgramm etc. directly to one of this keys.
The 0 key could be also be used for additional function, because you only need it after you pressed key 1-9. Or it could be some sort of hotkey to access a menu where key 1-9 is assigned with other functions.
The current TV programm should be shown directly after you switch to a channel with an information how long it lasts
By smart in forum Apps: MyRemote App for AppleReplies: 9Last Post: 02-16-2012, 06:03 AM
By Philips in forum Smart TV: User InterfaceReplies: 54Last Post: 02-07-2012, 08:54 AM
By sokolum in forum TV: User InterfaceReplies: 25Last Post: 09-01-2011, 06:41 PM
By kleinspr in forum TV: User InterfaceReplies: 12Last Post: 07-01-2011, 09:24 AM
By bta in forum Smart TV: IP-EPG Program GuideReplies: 4Last Post: 03-18-2011, 12:20 PM