Display replacement - 32PFL9705

[Sjekke]

Hi,

My display has been replaced because of different defective pixels and "pieping" noise of the Ambilight.
The noise is gone and it seems that the new display is better in "black/white" contrast.

My questions:

• How can I check my display that it has been replaced by a new BACKLIGHT LED and not an EDGE LED?
• When I activate my TV the logo "PHILIPS" is shown which was not the case before the replacement?
• Is it normal that my TV ask ones a day "a USB WIFI adapter is found", this was not the case before but in the meanwhile the latest firmware is installed. Hardware or software issue?
• Are there any "hidden" commands to perform some kinds of diagnostics?

Regards
Sjekke

[Chrissie18]

Hi,

My display has been replaced because of different defective pixels and "pieping" noise of the Ambilight.
The noise is gone and it seems that the new display is better in "black/white" contrast.

My questions:

• How can I check my display that it has been replaced by a new BACKLIGHT LED and not an EDGE LED?
• When I activate my TV the logo "PHILIPS" is shown which was not the case before the replacement?
• Is it normal that my TV ask ones a day "a USB WIFI adapter is found", this was not the case before but in the meanwhile the latest firmware is installed. Hardware or software issue?
• Are there any "hidden" commands to perform some kinds of diagnostics?

Regards
Sjekke

I think the best way to check is to create a picture, which is all black, but only one circle of white.
If the white is realy white and the black is realy black in stead of two times grey, I think you can assume that you really have full LED. I'm actually wondering if they can replace a different backlightin in a certain model. Also I think the LCD panel and the backlight LED array are two different components in the TV.

The Philips logo should have been there all the time. At least, I always saw it...

Don't know about the dongle: the 40" has build in WiFi (I actually thought the whole 9705 line had it...)

Try pressing 1 2 3 6 5 4 on the remote. This gives some information (after the Red, Blue and red screens). Press down for the different pages, Return to exit...

Greets,
Chris

[ali54]

if its the same tv and only the screen been replaced it be back led as they cant not chage the back light to side light