-
04-11-2012, 10:23 AM #1
- Join Date
- Apr 2012
- Location
- Sandnes, Norway
- Posts
- 1
- Points
- 560
- Level
- 6
- Thanks
- 0
- Thanked 0 Times in 0 Posts
- Rep Power
- 0
Connecting Universal remote control srp 3004/10
Hello!
I am trying to connect my universal remote control to my grundig ground-net box. The instruction goes as follows:
1. Turn your device on.
2. Press the STB button until it blinks twice and remains lit.
3. Find four-figure code in leaflet, enter using the digit buttons. The STB button will now blink twice and remain lit. If the button blinks twice fast, something is wrong. If so, start again.
4. Press and hold the ON/POWER button and immediately release it when the device switches off. This may take up to 30 seconds.
5. Turn on the device and check if the remote works.
I have gone through this procedure 12 times, and every time I encounter the same problem. Instructions 1, 2 and 3 go without any problems, then nothing happens on instruction 4. I have tried to enter 9999 instead of the correct code as per instructions, with the same result.
Please help!
Baffled and annoyed, Gunhild Drage
-
04-11-2012, 10:30 AM #2
- Join Date
- Jun 2011
- Posts
- 2,774
- Points
- 45,603
- Level
- 66
- Thanks
- 40
- Thanked 131 Times in 110 Posts
- Rep Power
- 10
Hi
I'm sorry but this is Accessory.
We do not support Universal Remotes in this Forum.
Please get in contact with you local support:
www.philips.com/contact
Regards
Thomas[many different Devices]-[many different Versions]-[Astra19,2°E/Cable Germany]-[50Mbit DSL]
FAQ's, Tipps und Tricks etc
Similar Topics
-
Spare remote control
By pposso in forum TV ForumReplies: 2Last Post: 02-01-2012, 10:50 AM -
Universal remote
By damir in forum TV ForumReplies: 2Last Post: 11-22-2011, 09:29 AM
Bookmarks