Topic: No video signal

Topic Tools
- Show Printable Version
- Subscribe to this Topic…
Search Topic
- Advanced Search
Display
- Linear Mode
- Switch to Hybrid Mode
- Switch to Topiced Mode

08-19-2012, 02:13 PM #1
getbackloretta

View Profile

View Forum Posts

Private Message

Give Away Points
New Member

Achievements:

Join Date

Aug 2012

Location

texas

Posts

1

Points

301
Level

3

Thanks

0

Thanked 0 Times in 0 Posts

Rep Power

0
No video signal

i have directv hd recorder connected to my phillips. yesterday, while watching a movie, suddenly there was no picture and the "no video signal" banner showed up. i have tried everything, calling directv and rebooting, disconnecting all the cables and reconnecting them, using new hdmi cable, etc. directv says it's the tv has quit recognizing the the signal from the box because it shows on their end its working properly. Does anyone have any ideas? Is there a way I can connect with regular cables, not the HDMI at least until I can get new cables, etc. to try to fix it?
thanks,
loretta
Reply With Quote
08-26-2012, 03:23 PM #2
Julian

View Profile

View Forum Posts

Private Message
New Member

Achievements:

Join Date

Aug 2012

Location

Beringen Belgium

Posts

5

Points

293
Level

3

Thanks

0

Thanked 0 Times in 0 Posts

Rep Power

0
I had the same problem yesterday.
I finally reset the tv by disconnecting it from the power for at least 30 sec. (pull the power cable form the mains)
Than reconnect the power cable and wait till the red light (led) comes on. (this can take 5 to 10 sec.)
Restart the tv with the remote control and wait at least 10 sec. before pressing any other buttons.
This might help.
Julian
Reply With Quote