- Rep Power
Problem with a aw7150/01p
I have an old Philips aw7150/01p - stereo radio cassette recorder. I want to add it a line in connector. I will solder the line in wires on the potentiometer pins. The problem is that I don't have the tape mechanism anymore and I don't know what pins should I short on the motherboard to make the amplification start in the tape mode. For the moment it's working only in the radio mode, but it's not a solution to mix the radio sound with the sound from the line in. I presume that the radio switch is doing the same thnig and it's powering also the amp circuit but I don't know which are those pins. I presume the info is in the service manual, but I don't have one.
Could you help me. please?
Thanks a lot.
Last edited by xire; 12-28-2012 at 08:53 AM.
Hello participants of the thread and forum members in general!
Hopefully your issue was dealt with and you are no longer facing it. Since the thread has been silent for some time now, I will proceed by closing it. If you still have the same question about the same issue or any similar issues arise feel free to start a new thread or contact one of us moderators to open this thread again.
Philips – Katerina